Firmware Update Hp V-m200

Hi, We've got about 15 HP V-M200 APs in our school district, all were replacements for our older Netgear products. The problem is that they require almost daily power cycles to continue functioning. They function correctly for a day or two, and then suddenly stop forwarding traffic.

Solved: I tried to upgrade the firmware on my V-M200 and it did not reboot and finish correctly. Now i cannot connect to retry. If i disconnect power i get power.

The SSID is still visible, and clients maintain their associations, but all network resources are inaccessible. A quick note, some of these access points are being powered by POE and others are not. The same problem exists regardless. Also, they all have different SSID's and all APs within the same building are operating on different channels. They obtain IP's through DHCP reservations tied to their wireless MAC addresses. The current firmware is 5.4.1.0-01-9867 which came preinstalled.

Black Gospel Soundtracks more. I am unable to find a new version. I can't help much except to say that I know what you're talking about. I got 10 of them last Christmas break to install at my medium-size independent school, and I had that same problem (still associated, but no network traffic) with some of them all the rest of the school year.

That was on the original firmware (at least 2 versions prior to yours), and then over the summer I upgraded them to the latest then (and still current on the support page) 5.4.1.0-01-9503, and it seems to have made all the difference. Bambi Surioara Fisierul Meu. Nothing changed in my configuration otherwise or switch settings otherwise. I don't suppose you can install a firmware version lower than what your AP came with. All of a sudden I'd get a frantic call that a classroom of laptops had a strong network connection but no connectivity. I could ping the AP without any problem, but the web interface was very slow, glacially slow to load. So that is how I got by, I created a single group of bookmarks that would all open in tabs with one click every morning, and then I could run down the tab line close the tabs of the APs which loaded right up.

If any were still spinning well after the others had loaded the home page, I would reboot them. This sucks, I know, but it minimized precious downtime in the school.

Not related to this but based on your description, I can tell you that my overall network stability and useability increased dramatically when I started using the same SSID throughout the building and followed Cisco's recommendation of only using channels 1,6,and 11, spread out as much as possible, but some overlap is inevitable. If AP's are on the same channel and can see each other, they cooperate and minimize the interference. Wireless traffic on adjacent channels is seen by APs as wireless interference, or noise, and it slows the throughput. I've recently experimented with some Open-Mesh wireless equipment, and that all uses the same channel, no matter how close together the APs are, and it all works very well.